More information

Download our Flexiteek brochure here
This brochure provides more information on Flexiteek material, including decking, top rails and hand rails.

FAQ about Flexiteek
If you have questions about Flexiteek, click the above link – there's a good chance of finding the right answer. Naturally, you may also contact us by e-mail or phone.

Dek-King installation video
The following video demonstrates how to install Flexiteek yourself. You may also order made-to-measure panels. Although they cost more, they reduce the installation effort.

Play installation video

Accessories

Back to Flexiteek starting page

WDK X06
Professional glue pump for applying items WDK X03 B and WDK X04 W. Can be used with all types of glue supplied in 600 ml sausage tubes.

WDK X03 B
Saba Sealtack 750 glue, black, supplied in 600 ml sausage tubes. Ideal for gluing Flexiteek profiles to various types of substrate. Also used to fill the grooves between planks. 600 ml of glue is normally sufficient for gluing an area of approximately 0.9 m².

WDK X04 W
Saba Sealtack 750 glue, cream, supplied in 600 ml sausage tubes. Ideal for gluing Flexiteek profiles to various types of substrate. Also used to fill the grooves between planks. 600 ml of glue is normally sufficient for gluing an area of approximately 0.9 m².

WDK X05
This spreader ensures uniform glue distribution over the surface. The grooves formed by the spreader cause the glue to squeeze into the T-shaped grooves on the bottom of the Flexiteek profiles. This forms a very strong bond and leaves little room for water.

WDK X01 T
Transparent Stelmax 1985 glue, supplied in 135-g tubes and intended to be used to bond the joints of the various profiles. One tube is sufficient for bonding approximately 1 m² of profiles with a width of 50 mm. A single tube is sufficient for bonding much larger areas when combined profiles or wider profiles are used.

WDK X01 B
Black Stelmax 1985 glue, supplied in 135-g tubes and intended to be used to bond the joints of the various profiles. One tube is sufficient for bonding approximately 1 m² of profiles with a width of 50 mm. A single tube is sufficient for bonding much larger areas when combined profiles or wider profiles are used.

WDK X09
Special shears for cutting Flexiteek profiles. With these shears you can make angle cuts very precisely. Note: Other shears are available from other sources, but most of them have a cutting length of 50 mm, which not quite enough for trimming profiles at a angle.

WDK X07
The extensible roller helps you press the material firmly and uniformly against the underlying surface. This is necessary in order to press the glue into the T-shaped grooves on the bottom of the profiles. If the profiles are not pressed down uniformly, the irregularities will be visible in the finished deck.

WDK X08
Blue masking tape with excellent adhesion on various types of surface. Does not leave any residue and is easy to remove.


Nidra delivers worldwide – visit our webshop